Are you ready for extremely high-quality, flicker-free HDMI output from your A2000? When I first got this, I thought just another flicker fixer, but this is a really good flicker fixer with an on-screen display.

New High-quality RGB2HDMI for the A2000 video slot (Raspberry Pi Zero 1/2 required). This is probably the best quality flicker-free video possible from an Amiga. Installation instructions are included.

• Fully assembled, Brilliant "Commodore blue" premium v2.2 PCB with Xilinx CPLD.
• CPLD version for maximum configure-ability/programmability and to avoid "sparkling pixel" artifacts.
• works great for non-RTG standard display modes such as Games, boot screen, etc.
• Pre-flashed and ready, but you will still need to install the software on the SD Card for the Pi.
• All high-quality hardware components installed, including the power-to-Raspberry Pi LED (Blue LED) and fuse
• on-screen menu that enables adjusting video including auto-calibration, flashing firmware, profiles, and more.
• connect your monitor to the Raspberry Pi's HDMI port.
• works with low-cost Raspberry Pi Zero and Raspberry Pi Zero 2 (with the latest software).
• works with a small and economical SD Card in the Raspberry Pi Zero, like 128MB; the software only takes approx. 30MB (depending on version)
• works well with most any expansion such as a PiStorm and Accelerators. Basically works independently.
• automatically boots/shutoff with the Amiga

A2000CPLDSlot v2.2 board (plugs directly into the video slot and Raspberry Pi Zero)

What you will need (not included):

• Raspberry Pi Zero, Raspberry Pi Zero 2, or Raspberry Pi 3/4 (requires an adapter to fit) with Header Pins installed
• SD Card to install the software.
• Micro-HDMI cable or adapter to connect to a monitor.